Email Address

[email protected]

Phone Number

+0086-371-86162511

astm recycled aggregates

Get In Touch

Recycled Concrete—A Source for New Aggregate ASTM

No significant increase in the strength of recycled aggregate concrete was obtained by reducing the W/C ratio below 0.40. It is indicated that the quality of recycled aggregate concrete will improve with the quality of recycled mortar or if the recycled material has a high aggregate-cement ratio.

Get Quote

Standard Practice for Reclamation of Recycled Aggregate

ASTM D8038-16, Standard Practice for Reclamation of Recycled Aggregate Base (RAB) Material, ASTM International, West Conshohocken, PA, 2016, astm.org.

Get Quote

USE OF RECYCLED CONCRETE AGGREGATES

Jan 12, 2011· ASTM C33-03 and C330-05 DSA IR 19-3 Fly Ash and Natural Pozzolans Used in Concrete . Issued 01-12-11 . Discipline: Strutural c. This Interpretation of Regulations (IR) is intended for use by the Division of the State Architect (DSA) staff, and as a resource for Source of recycled aggregates are identified,

Get Quote

Aggregates for Concrete as per American Standards ASTM

Apr 19, 2020· đź•‘ Reading time: 1 minute The aggregates used in the production of concrete are inert granular materials such as gravel, crushed stone, sand, slag, recycled concrete, and geosynthetic aggregates. The aggregates may be natural, manufactured, or recycled. Fig 1: Aggregates used in production of concrete. The aggregates are broadly classified into two types based on []

Get Quote

ASTM releases standard that supports recycling concrete

Jan 16, 2017· “Quite simply, this standard recognizes unused concrete in a fresh state as a potential ingredient for a new concrete batch,” says ASTM member Rich Szecsy, president, Texas Aggregates and Concrete Association. “In other words, recycled fresh concrete can be treated as a raw-material component just like water, aggregates and cement.”

Get Quote

Aggregates for Concrete

Chapter 7—Recycled aggregates, p. E1-23 7.1—Introduction to recycled aggregates 7.1.1—Definition 7.1.2—Properties Chapter 8—Selected references on aggregates, p. E1-24 aggregate for concrete is ASTM C 33. Synthetic aggregates may be either byproducts of an industrial process, in the case of blast-furnace slag, or products of

Get Quote

Edil -No. 68 Specifications for Recycled Materials Used as

Subcommittee entitled “Standard Guide for Recycled Aggregates As Unbound Roadbase”, which covers both RAP and RCA and aimed at crushers. This guide is s determined by ASTM D 854, Absorption of coarse aggregate were determined by ASTM C127-07, USCS classification determined by ASTM D 2487, AASHTO classification determined

Get Quote

USE OF RECYCLED CONCRETE AGGREGATES

Jan 12, 2011· ASTM C33-03 and C330-05 DSA IR 19-3 Fly Ash and Natural Pozzolans Used in Concrete . Issued 01-12-11 . Discipline: Strutural c. This Interpretation of Regulations (IR) is intended for use by the Division of the State Architect (DSA) staff, and as a resource for Source of recycled aggregates are identified,

Get Quote

PennDOT RECYCLING MATERIAL BRIEF Recycled Concrete

Recycled aggregates have exhibited good particle shape, high absorptions, and low specific gravity compared with conventional mineral aggregates. Additionally, a number of agencies have found Deleterious Components ASTM C40, ASTM 295, ASTM C142 ASTM D2419 Fines AASHTO M80 Specific Gravity ASTM C127, AASHTO T85; Fine Particles: ASTM C128

Get Quote

Recycled Base Aggregates in Pavement Applications

ASTM D2940 aggregate requirements. Strength: The bearing strength depends on the proportion of RAP to other aggregates, and the fraction of fine material. There seems to be a trend of lower CBR for material pulverized in place, due to the fines, compared to materials that are mixed pulverized and screened off-site.

Get Quote

Sustainable normal and high strength recycled aggregate

Dec 01, 2017· Recycled coarse aggregates are expected to exceed ASTM requirements for the Los Angeles Abrasion test. The compressive strength of RAC depends on the strength of the original concrete and is largely influenced by the water-cement ratios (w/c) of the original and the recycled concretes.

Get Quote

Relationship Between Gas Adsorption and the ASTM

Dec 01, 2003· In this work, an experimental analysis is described of specimens of recycled concrete (RC) made with replacement of natural aggregate with recycled aggregate originating from concrete (RCA). An experimental analysis to obtain the shrinkage

Get Quote

Aggregates for Concrete

Chapter 7—Recycled aggregates, p. E1-23 7.1—Introduction to recycled aggregates 7.1.1—Definition 7.1.2—Properties Chapter 8—Selected references on aggregates, p. E1-24 aggregate for concrete is ASTM C 33. Synthetic aggregates may be either byproducts of an industrial process, in the case of blast-furnace slag, or products of

Get Quote

Aggregates for Concrete University of Memphis

Recycled concrete, or crushed waste concrete, is a feasible source of aggregates and an economic reality, especially where good aggregates are scarce. Conven-tional stone crushing equipment can be used, and new (specific gravity) fine aggregate ASTM C 128 (AASHTO T 84)

Get Quote

Performance of Recycled Ceramic Waste as Aggregates in

Performance of Recycled Ceramic Waste as Aggregates in Asphalt Mixtures 239 The percentage indicated is calculated based on the total weight of aggregates for the selected gradation. The mixtures were designed in accordance with Marshall procedure outlined in ASTM D 1559. A total of 90 specimens were prepared at the predetermined

Get Quote

Mechanical Properties Of Recycled Aggregates Concrete

1.2.2 Recycled Aggregates The slump test is prescribed by ASTM C 143-90a and BS 1881 Part 102:1983.The mould for the slump test is frustum of cone, 300mm (12in) high. It is placed on a smooth surface with the smaller opening at the top, and filled with concrete in three layers. Each layer is tamped 25 times with a standard 16 mm (5/8in

Get Quote

Recycled Concrete Lehigh Hanson, Inc.

The recycled aggregate is used as soon as it is processed. Recycled concrete currently supplies about 5% of aggregate use. The bulk of recycled aggregates about 68 % is used as road base. The remainder is used for new concrete mixes (6%), asphalt (9 %) and fill. Recycling concrete features both cost savings and environmental benefits:

Get Quote

Design of Normal Strength Concrete Mixtures with Recycled

coarse aggregates in new construction, it would be possible to substantially reduce the demand for new aggregates. Recycled concrete aggregates (RCA) can readily pass the prescriptive requirements for coarse aggregates in structural concrete (ASTM 2009); however, the

Get Quote

Crushed Concrete Aggregates Properties and Uses of

Crushed concrete aggregate conform with ASTM international with regard to los angeles abrasion loss. 6. Contaminants Present of contaminants in recycled aggregate decline strength of concrete produced with this aggregate. Influence of Recycled Aggregate on Concrete Properties 1. Concrete

Get Quote

Tests on aggregates, fillers, recycled aggregates Geos

Affinity between aggregate and bitumen: EN 12697-11: B: L: Aggregate type: Method GEOS: Accelerated test by “Microbar” NF P 18-594 § 5.2: B: L: Accelerated test on mortar by UAMBT: ASTM C 1260: Atterberg limits: CEN ISO TS 17892-12: B: NF P 94-051: L: Afl. PM Hfdst. 01 (01.03) B: Clay pellets: NF P 18 545 § 10.1.6: Percentage of

Get Quote

Performance of Hot Mix Asphalt Mixtures Made of Recycled

Journal of Testing and Evaluation Muhammad Masood Rafi,1 Adnan Qadir,2 Sajjad Ali,3 and Salman Hameed Siddiqui4 DOI: 10.1520/JTE20130004 Performance of Hot Mix Asphalt Mixtures Made of Recycled Aggregates VOL. 42 / NO. 2 / MONTH 2013 J_ID: JTE DOI: 10.1520/JTE20130004 Date: 30-September-13 Stage: Page: 1 Total Pages: 14 PROOF COPY [JTE20130004] Journal of Testing and

Get Quote
Latest News